This unit attaches to one bending bar. After heating, it melts through about two-thirds of the sheet forming a deep V-groove. The sheet is bent with a sharp, non-radius bend resulting in a contact weld along the juncture of the groove.

Excess material forms an extra bead along the inside of the bend. The result is a sharp attractive bend with a reinforced inner joint.

Here is an inexpensive way to accomplish what would otherwise require extensive investment in complicated machinery.

Set Includes: One bar, one sword, one base, one controller (115 VAC). 240V option also available.

8' Sword Set ships by truck or FedEx only. We will contact you with shipping cost information.

Use of Heat Resistant Gloves highly recommended.